Air-side particulate fouling of microchannel heat exchangers: Experimental comparison of air-side pressure drop and heat transfer with plate-fin heat exchanger (Englisch)
- Neue Suche nach: Bell, I. H.
- Neue Suche nach: Groll, E. A.
- Neue Suche nach: Bell, I. H.
- Neue Suche nach: Groll, E. A.
In:
APPLIED THERMAL ENGINEERING
;
31
, 5
;
742-749
;
2011
-
ISSN:
- Aufsatz (Zeitschrift) / Print
-
Titel:Air-side particulate fouling of microchannel heat exchangers: Experimental comparison of air-side pressure drop and heat transfer with plate-fin heat exchanger
-
Beteiligte:Bell, I. H. ( Autor:in ) / Groll, E. A. ( Autor:in )
-
Erschienen in:APPLIED THERMAL ENGINEERING ; 31, 5 ; 742-749
-
Verlag:
- Neue Suche nach: Elsevier Science B.V., Amsterdam.
-
Erscheinungsdatum:01.01.2011
-
Format / Umfang:8 pages
-
ISSN:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Print
-
Sprache:Englisch
- Neue Suche nach: 621.402
- Weitere Informationen zu Dewey Decimal Classification
-
Klassifikation:
DDC: 621.402 -
Datenquelle:
© Metadata Copyright the British Library Board and other contributors. All rights reserved.
Inhaltsverzeichnis – Band 31, Ausgabe 5
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 593
-
Special issue: 2nd micro and nano flows conferenceLewis, John / Karayiannis, Tassos G. et al. | 2010
- 594
-
Compact/micro-heat exchangers – Their role in heat pumping equipmentKew, Peter A. / Reay, David A. et al. | 2010
- 602
-
Microstructure devices for water evaporationAnurjew, Eugen / Hansjosten, Edgar / Maikowske, Stefan / Schygulla, Ulrich / Brandner, Juergen J. et al. | 2010
- 610
-
Investigation of boiling and bubble confinement in a high aspect ratio micro-channelWang, Y. / Sefiane, K. / Bennacer, R. et al. | 2010
- 619
-
Analysis of the topography of microchannels with different sizesLuke, Andrea / Struebing, Hannes / Mueller, Bjoern C.F. et al. | 2010
- 627
-
Effect of micro fin geometry on natural convection heat transfer of horizontal microstructuresMahmoud, S. / Al-Dadah, R. / Aspinwall, D.K. / Soo, S.L. / Hemida, H. et al. | 2010
- 634
-
Residence time distribution studies in microstructured plate reactorsCantu-Perez, Alberto / Bi, Shuang / Barrass, Simon / Wood, Mark / Gavriilidis, Asterios et al. | 2010
- 640
-
Molecular dynamics simulation for microscope insight of water evaporation on a heated magnesium surfaceYang, X. / Yan, Y.Y. et al. | 2010
- 649
-
LBM, a useful tool for mesoscale modelling of single-phase and multiphase flowYan, Y.Y. / Zu, Y.Q. / Dong, Bo et al. | 2010
- 656
-
Prediction and evolution of drop-size distribution for a new ultrasonic atomizerTembely, Moussa / Lecot, Christian / Soucemarianadin, Arthur et al. | 2010
- 668
-
EditorialProfessor Reay, David A. et al. | 2010
- 670
-
A note on the article titled: Experimental and numerical investigation of solid particles thermal energy storage unit, by: A. Benmansour, M.A. Hamdan, A. Bengeuddach, published in Applied Thermal Engineering, 26, 513–518 (2006)Moradi, Maryam / Rahimi, Amir / Hatamipour, Mohammad Sadegh et al. | 2010
- 674
-
Experimental and theoretical study of thermal aspects of the hot stamping processAbdulhay, B. / Bourouga, B. / Dessain, C. et al. | 2010
- 686
-
Steady state operation of a copper–water LHP with a flat-oval evaporatorBecker, S. / Vershinin, S. / Sartre, V. / Laurien, E. / Bonjour, J. / Maydanik, Yu.F. et al. | 2010
- 696
-
Exergy based simulation model for vehicle HVAC operationMarachlian, Jacques / Benelmir, Riad / El Bakkali, Amin / Olivier, Gérard et al. | 2010
- 701
-
Effect of tube diameter on the specific energy consumption of the ice making processTangthieng, C. et al. | 2010
- 708
-
The effect of svelteness on the bifurcation angles role in pressure drop and flow uniformity of tree-shaped microchannelsGhaedamini, H. / Salimpour, M.R. / Mujumdar, Arun S. et al. | 2010
- 717
-
Tests of prototype PCM ‘sails’ for office coolingSusman, Gideon / Dehouche, Zahir / Cheechern, Tanawat / Craig, Salmaan et al. | 2010
- 727
-
Sizing and selection of heat exchanger at defined saving–investment ratioAğra, Özden et al. | 2010
- 735
-
Two-dimensional transient thermal analysis of PCM canister of a heat pipe receiver under microgravityXiaohong, Gui / Bin, Lin / Yongxian, Guo / Xiugan, Yuan et al. | 2010
- 742
-
Air-side particulate fouling of microchannel heat exchangers: Experimental comparison of air-side pressure drop and heat transfer with plate-fin heat exchangerBell, Ian H. / Groll, Eckhard A. et al. | 2010
- 750
-
Coordinated energy management of vehicle air conditioning systemKhayyam, Hamid / Kouzani, Abbas Z. / Hu, Eric J. / Nahavandi, Saeid et al. | 2010
- 765
-
Residential heat pump heating performance with single faults imposedYoon, Seok Ho / Payne, W. Vance / Domanski, Piotr A. et al. | 2010
- 772
-
Thermal analysis of underground electrical power cables buried in non-homogeneous soilsde Lieto Vollaro, Roberto / Fontana, Lucia / Vallati, Andrea et al. | 2010
- 779
-
Optimization of heat exchanger networkGorji-Bandpy, Mofid / Yahyazadeh-Jelodar, Hossein / Khalili, Mohammadtaghi et al. | 2010
- 785
-
Analysis of small size combined cycle plants based on the use of supercritical HRSGFranco, Alessandro et al. | 2010
- 795
-
Comparison between miniature periodic two-phase thermosyphons and miniature LHP applied to electronic cooling equipmentFilippeschi, S. et al. | 2010
- 803
-
Optimizing the geometrical parameters of a spark ignition engine: Simulation and theoretical toolsCurto-Risso, P.L. / Medina, A. / Calvo Hernández, A. et al. | 2010
- 811
-
CFD model for turbocharger journal bearing performancesDeligant, M. / Podevin, P. / Descombes, G. et al. | 2010
- 820
-
Heat transfer correlations of forced convective boiling for pure refrigerants in micro-fin tubesChiou, C.B. / Lu, D.C. / Chen, C.C. / Chu, C.M. et al. | 2010
- 827
-
The role of real gas Brayton cycles for the use of liquid natural gas physical exergyAngelino, Gianfranco / Invernizzi, Costante M. et al. | 2010
- 834
-
Analytical modeling of wet compression of gas turbine systemsKim, Kyoung Hoon / Ko, Hyung-Jong / Perez-Blanco, Horacio et al. | 2010
- 841
-
Combustion performance of an aluminum melting furnace operating with natural gas and liquid fuelNieckele, Angela O. / Naccache, Monica F. / Gomes, Marcos Sebastião P. et al. | 2010
- 852
-
A strategy for the economic optimization of combined cycle gas turbine power plants by taking advantage of useful thermodynamic relationshipsGodoy, E. / Benz, S.J. / Scenna, N.J. et al. | 2010
- 872
-
Alternative cycles based on carbon dioxide for central receiver solar power plantsChacartegui, R. / Muñoz de Escalona, J.M. / Sánchez, D. / Monje, B. / Sánchez, T. et al. | 2010
- 880
-
Experimental study on effective range of miniature oscillating heat pipesLin, Zirong / Wang, Shuangfeng / Chen, Jinjian / Huo, Jiepeng / Hu, Yanxin / Zhang, Winston et al. | 2010
- 887
-
Experimental study of heat transfer and pressure drop in micro-channel based heat sinks with tip clearanceReyes, M. / Arias, J.R. / Velazquez, A. / Vega, J.M. et al. | 2010
- 894
-
Optimizing energy consumption of a water-loop variable-speed heat pump systemYuan, Shui / Grabon, Michel et al. | 2010
- 902
-
Towards the control of car underhood thermal conditionsKhaled, Mahmoud / Harambat, Fabien / Peerhossaini, Hassan et al. | 2010
- 911
-
Heat exchangers and the performance of heat pumps – Analysis of a heat pump databaseKim, D.S. / Moretti, I. / Huber, H. / Monsberger, M. et al. | 2010
- 921
-
A numerical study on heat transfer performance of microchannels with different surface microstructuresLiu, Y. / Cui, J. / Jiang, Y.X. / Li, W.Z. et al. | 2010
- 932
-
A simplified model for analysis of heat and mass transfer in a direct evaporative coolerFouda, A. / Melikyan, Z. et al. | 2010
- 937
-
Thermal analysis of orthotropic annular fins with contact resistance: A closed-form analytical solutionMustafa, M.T. / Zubair, Syed M. / Arif, A.F.M. et al. | 2010
- 946
-
Theoretical investigation into condensation heat transfer on horizontal elliptical tube in stationary saturated vapor with wall suctionChang, Tong-Bou / Yeh, Wen-Yu et al. | 2010
- 954
-
Exergy transfer and parametric study of counter flow wet cooling towersWang, Li / Li, Nianping et al. | 2010
- 961
-
Experimental analysis of the thermal entrainment factor of air curtains in vertical open display cabinets for different ambient air conditionsGaspar, Pedro Dinis / Carrilho Gonçalves, L.C. / Pitarma, R.A. et al. | 2010
- 970
-
Experimental investigations on heat transfer in phase change materials (PCMs) embedded in porous materialsZhou, D. / Zhao, C.Y. et al. | 2010
- 978
-
Field winding fault diagnosis in DC motors during manufacturing using thermal monitoringManana, M. / Arroyo, A. / Ortiz, A. / Renedo, C.J. / Perez, S. / Delgado, F. et al. | 2010
- 984
-
A practical plate-fin heat sink modelWu, Hsin-Hsuan / Hsiao, Yuan-Yuan / Huang, Hsiang-Sheng / Tang, Ping-Huey / Chen, Sih-Li et al. | 2010
- IFC
-
Editorial board| 2011