The effect of frequency on fretting in a micro-spherical contact (Englisch)
- Neue Suche nach: Li, Longqiu
- Neue Suche nach: Etsion, Izhak
- Neue Suche nach: Talke, Frank E.
- Neue Suche nach: Li, Longqiu
- Neue Suche nach: Etsion, Izhak
- Neue Suche nach: Talke, Frank E.
In:
Wear - An International Journal on the Science and Technology of Friction, Lubrication and Wear
;
270
, 11-12
;
857-865
;
2011
-
ISSN:
- Aufsatz (Zeitschrift) / Print
-
Titel:The effect of frequency on fretting in a micro-spherical contact
-
Weitere Titelangaben:Einfluss der Frequenz auf die Kontaktkorrosion bei einem mikrosphärischen Kontakt
-
Beteiligte:
-
Erschienen in:
-
Verlag:
-
Erscheinungsdatum:2011
-
Format / Umfang:9 Seiten
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Print
-
Sprache:Englisch
-
Schlagwörter:
-
Datenquelle:
Inhaltsverzeichnis – Band 270, Ausgabe 11-12
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 725
-
Improvement of wear resistance for carbon steel under unlubricated sliding and variable loading conditionsGoto, H. / Amamoto, Y. et al. | 2010
- 737
-
Polytetrafluoroethylene (PTFE) fiber reinforced polyetheretherketone (PEEK) compositesVail, J.R. / Krick, B.A. / Marchman, K.R. / Sawyer, W. Gregory et al. | 2010
- 742
-
The twin-ring tribometer—Characterizing sliding wear of metals excluding the effect of contact configurationsHiratsuka, K. / Yoshida, T. et al. | 2011
- 751
-
Effect of constitutive behavior on scratch visibility resistance of polymers—A finite element method parametric studyHossain, Mohammad Motaher / Jiang, Han / Sue, Hung-Jue et al. | 2011
- 760
-
A novel energy-based generic wear model at the asperity levelDe Moerlooze, Kris / Al-Bender, Farid / Van Brussel, Hendrik et al. | 2011
- 771
-
Flank wear of multi-layer coated toolPark, Kyung-Hee / Kwon, Patrick Y. et al. | 2011
- 781
-
On the correlation between wear and entropy in dry sliding contactAghdam, A.B. / Khonsari, M.M. et al. | 2011
- 791
-
Exploring potential of Micro-Raman spectroscopy for correlating graphitic distortion in carbon fibers with stresses in erosive wear studies of PEEK compositesSharma, Mohit / Bijwe, Jayashree / Singh, Kuldeep / Mitschang, Peter et al. | 2011
- 800
-
Strain hardening of austenite in Fe–Cr–C–V alloys under repeated impactFilipovic, Mirjana / Romhanji, Endre et al. | 2011
- 806
-
Microstructural characterization and tribocorrosion behaviour of Al/Al3Ti and Al/Al3Zr FGMsFerreira, S.C. / Sequeira, P.D. / Watanabe, Yoshimi / Ariza, E. / Rocha, L.A. et al. | 2011
- 815
-
Validation of proposed metrics for two-body abrasion scratch test analysis standardsKobrick, Ryan L. / Klaus, David M. / Street Jr., Kenneth W. et al. | 2011
- 823
-
Effect of load and carbide orientation on abrasive wear resistance of white cast ironCoronado, J.J. et al. | 2011
- 828
-
In situ monitoring and prediction of progressive joint wear using Bayesian statisticsAn, Dawn / Choi, Joo-Ho / Schmitz, Tony L. / Kim, Nam H. et al. | 2011
- 839
-
Tribological investigation on friction and wear behaviour of coatings for hot sheet metal formingKondratiuk, Jens / Kuhn, Patrick et al. | 2011
- 850
-
Application of hard coatings for blanking and piercing toolsPodgornik, B. / Zajec, B. / Bay, N. / Vižintin, J. et al. | 2011
- 857
-
The effect of frequency on fretting in a micro-spherical contactLi, Longqiu / Etsion, Izhak / Talke, Frank E. et al. | 2011
- 866
-
Erosive wear of borosilicate glass by low velocity unidirectional impact of abrasive spheresMohajerani, A. / Spelt, J.K. et al. | 2011
- 876
-
Numerical simulation of the third body in fretting problemsBasseville, Stéphanie / Héripré, Eva / Cailletaud, Georges et al. | 2011
- 888
-
Elastic–plastic spherical contact under cyclic tangential loading in pre-slidingZolotarevskiy, V. / Kligerman, Y. / Etsion, I. et al. | 2011
- 895
-
Adhering layer formation and its effect on the wear of coated carbide tools during turning of a nickel-based alloyXue, Chao / Chen, Wuyi et al. | 2011
- 903
-
The influence of erodent hardness on the erosion behavior of detonation sprayed WC-12Co coatingsBabu, P. Suresh / Basu, Bikramjit / Sundararajan, G. et al. | 2011
- 914
-
An electro-mechanical contact analysis of a three-dimensional sinusoidal surface against a rigid flatShah, Sameer / Krithivasan, Vijaykumar / Jackson, Robert L. et al. | 2011
- 922
-
Reduction of particle embedding in solid particle erosion of polymersGetu, H. / Spelt, J.K. / Papini, M. et al. | 2011
- 929
-
Corrigendum to “A method for obtaining the temperature distribution at the interface of sliding bodies” [Wear 266 (2009) 721–732]Bansal, Dinesh G. / Streator, Jeffrey L. et al. | 2011
- CO2
-
Editorial Board| 2011