Bitte wählen Sie ihr Lieferland und ihre Kundengruppe
The continuous decrease in size of transistors has allowed more components to be integrated in a single unit area and brings a range of opportunities as well as problems to the electronic packaging industry. To meet these challenges, the introduction of Carbon Nanotubes (CNT), which display a series of extraordinary properties, have attracted great interest. CNTs pose great difficulties to direct experimental study, thus theoretical study becomes a valuable alternative. This thesis presents several examples of theoretical studies aiming at CNT-based applications. Classic Molecular dynamics simulation (MDS) and continuum modeling are adopted as key methodologies in these studies. Although it is a theoretical work, this thesis presents exciting findings that point to possible practical applications. Chapter 2 presents two direct applications of CNT in electronic packaging, i.e. thermal management and interconnection. The thermal management is related to the use of CNTs in a micro-channel cooler construction due to its excellent thermal conductivity. In this example, the thermal interface resistance between CNT and adhesive could influence the heat transfer between the heat generator and the CNT fins in the cooler. This influence shall be evaluated. Thus in section 2.1, the thermal conductivity of epoxy matrix for thermal conductive adhesive (TCA) is studied by MDS using the Nonequilibrium Molecular Dynamics Method (NEMD). The thermal resistivity at the interface between the carbon nanotube and the polymer is estimated to be 33.262 X 10-8 m²K/W, which is consistent with previous studies. Both thermal management and interconnection with CNTs requires peeling off the CNT forest from the metal catalysts where CNTs were grown. Therefore an investigation of the bonding strength between metal and SWNT is presented. Two kinds of metal, i.e. iron and nickel are studied. Simulation results reveal that to debond the joint, a force greater than 31.7 nN is needed for Fe-SWNTjoint, and for Ni-SWNTjoint the required force is 3.5 nN. Then buckling behaviors of CNT are investigated and its potential applications presented. These investigations can be used in the electronic packaging applications. It starts from formulation work on the radial buckling of CNT. The results of this work are then verified with MDS which predicts an enhanced critical pressure for buckling of CNT due to an inserted linear carbon chain. This is followed by a theoretical analysis on the boundary condition effect on axial bucking of chiral CNT with MDS. It finds that boundary conditions can influence critical bucking strain by 20%. Hereafter a molecular gun that utilizes bending buckling of a telescope CNT is studied, which shows the inner tube of the doublewalled carbon nanotube (DWNT) can be shot out with a speed up to 500 m/s.