Eine allgemeine Empfehlung über eine optimale Position einer KWKA auf einer Dachoberfläche lässt sich aus dieser Messreihe kaum ableiten. Zu spezifisch sind die Einflüsse rund um das jeweilige Gebäude und auch die Effekte der Dachstruktur und Dachaufbauten auf die Windströmung. Zusammengefasst kann gesagt werden das KWKA auf Gebäuden sehr wohl einen Sinn machen, da man durch die Gewinnung an Höhe in eine stärkere Luftströmung gelangt, jedoch ist die Installation auf jedem Gebäudedach getrennt zu untersuchen. Die folgende Vorgehensweise wäre sehr interessant: ausgehend von den Wetterdaten der ZAMG wird über die Strömungssimulation ein Punkt am Gebäude ausgewählt und die endgültigen Ergebnisse werden mit der lokalen Messung bestätigt. Die Resultate der in diesem Projekt durchgeführten numerischen Strömungssimulationen verdeutlichen, dass die numerische Strömungssimulation (computational fluid dynamics - CFD) das beste ingenieurtechnische Werkzeug darstellt, um all die Informationen bereitzustellen, die für das Verständnis der Probleme, die bei der genauen Positionierung von KWKA im städtischen Bereich auftreten können, nötig sind. Um ein städtisches Windströmungsfeld zu bestimmen, ist aufgrund der großen Abmessungen eine ausreichende Datensammlungen durch Feldmessungen praktisch unmöglich. Bei Laborexperimenten besteht das Problem, dass die reale Windcharakteristik nur sehr schwer reproduziert werden kann. Hingegen liefert die Lösung der physikalischen Grundgleichungen für den Transport der Luft durch das Berechnungsgebiet unter Berücksichtigung der herrschenden Randbedingungen vollen Einblick in die dreidimensionale städtische Windströmungssituation und alle relevanten Strömungseffekte. Aber auch für CFD Simulationen ist die Wahl geeigneter Randbedingungen, d.h. speziell die Modellierung der Windverhältnisse am Rand des Berechnungsgebietes essentiell. Diese kann aus Feldmessungen abgeleitet werden. Die Kombination der Durchführung von Feldmessungen mit der Durchführung von numerischen Simulationen, in die die Messdaten als Randbedingungen eingehen, liefert die optimalen Ergebnisse.
A general recommendation on the optimal position of a KWKA on a roof surface can hardly be derived from this single project, given the specific influences around the respective building as well as the effects of the roof structure and roof structures to the wind flow. In a summary it can be said that SWT buildings can make sense, because of the higher velocities reached: the installation, however, must be examined separately for each building roof. Nevertheless, the following procedure could be very interesting: based on the flow simulations (using the meteorological data of the ZAMG for boundary conditions, and the wind class distribution) one specific point on the building is selected, and then the final results confirmed with the local measurement. From the results of the performed numerical simulations it can clearly be seen that the computational fluid dynamics (CFD) is the best engineering tool which can provide all information necessary for understanding the problems of exact positioning of SWT in urban environment - and more importantly, gives the solutions to these problems. Namely, on such a large scale it is practically impossible to acquire by means of field measurements a sufficient amount of data necessary to reconstruct the urban flow field totality, whereas the laboratory measurements can hardly reproduce the actual wind characteristics. On the other hand, however, by solving the governing equations CFD provides a full insight into urban flow situation and all relevant flow characteristics. The open issues for CFD simulations, such as the boundary conditions and wind characteristics, can be estimated from the field measurements, and in that respect the combination of numerical simulations supplied with the field data obtained from measurements.