1D cyclic yield model independent of load spectrum characteristics and its application to Inconel 718 (Englisch)
- Neue Suche nach: Klotz, T.
- Neue Suche nach: Blas, S.
- Neue Suche nach: Lévesque, M.
- Neue Suche nach: Brochu, M.
- Neue Suche nach: Klotz, T.
- Neue Suche nach: Blas, S.
- Neue Suche nach: Lévesque, M.
- Neue Suche nach: Brochu, M.
In:
Mechanics of Materials
;
109
;
34-41
;
2017
-
ISSN:
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:1D cyclic yield model independent of load spectrum characteristics and its application to Inconel 718
-
Beteiligte:Klotz, T. ( Autor:in ) / Blas, S. ( Autor:in ) / Lévesque, M. ( Autor:in ) / Brochu, M. ( Autor:in )
-
Erschienen in:Mechanics of Materials ; 109 ; 34-41
-
Verlag:
- Neue Suche nach: Elsevier Ltd
-
Erscheinungsdatum:21.03.2017
-
Format / Umfang:8 pages
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Schlagwörter:Inconel 718 , Cyclic yielding , Low cycle fatigue , Constitutive equations , Softening , E , Young modulus , ν , Poisson’s ratio , σy0.2% , 0.2% offset tensile yield strength , σy0.05% , 0.05% offset tensile yield strength , σu , ultimate strength , El. , elongation , AR. , area reduction , Bal. , balance , Rε , strain ratio , , strain rate , f , flow function , N , total number of experiments , σnum , predicted stress , Δεtot/2 , strain amplitude , Δσ/2 , stress amplitude , σ , applied stress , χ , back stress , R , yield surface evolution , k , initial yield strength , ai, Ci , back stress parameters , εp , plastic strain within a half cycle , p , total accumulated plastic strain , Q , elastic field size saturation value , b , elastic field size hardening rate , α, β , elastic field size evolution parameters , F , cost function , M , total number of data point , σexp , experimentally measured stress
-
Datenquelle:
Inhaltsverzeichnis – Band 109
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 1
-
Combination of in-situ SEM tensile test and FFT-based crystal elasticity simulations of Ti-6Al-4V for an improved description of the onset of plastic slipHémery, S. / Nait-Ali, A. / Villechaise, P. et al. | 2017
- 11
-
Theoretical prediction of interfacial properties of PBT/CNT nanocomposites and its experimental evaluationChopra, Swamini / Deshmukh, Kavita A. / Peshwe, Dilip et al. | 2017
- 18
-
Continuous gradient and discretized layered designs for control of stress wave scatteringAmirkhizi, Alireza V. et al. | 2017
- 26
-
Nucleation and growth mechanisms of nanoscale deformation twins in hexagonal-close-packed metal magnesiumFeng, H. / Fang, Q.H. / Liu, B. / Liu, Y. / Liu, Y.W. / Wen, P.H. et al. | 2017
- 34
-
1D cyclic yield model independent of load spectrum characteristics and its application to Inconel 718Klotz, T. / Blas, S. / Lévesque, M. / Brochu, M. et al. | 2017
- 42
-
Maxwell–Wagner–Sillars mechanism in the frequency dependence of electrical conductivity and dielectric permittivity of graphene-polymer nanocompositesXia, Xiaodong / Zhong, Zheng / Weng, George J. et al. | 2017
- 51
-
A two-phase integrated flow-stress process model for composites with application to highly compressible phasesNiaki, Sina Amini / Forghani, Alireza / Vaziri, Reza / Poursartip, Anoush et al. | 2017
- 67
-
A microstructure sensitive grain boundary sliding and slip based constitutive model for machining of Ti-6Al-4VFernandez-Zelaia, Patxi / Melkote, Shreyes / Marusich, Troy / Usui, Shuji et al. | 2017
- 82
-
The oblique impact of a rigid sphere on a power-law graded elastic half-spaceWillert, E. / Popov, V.L. et al. | 2017
- 88
-
Effect of microstructure on dynamic shear localisation in Alloy 718Johansson, Joakim / Persson, Christer / Testa, Gabriel / Ruggiero, Andrew / Bonora, Nicola / Hörnqvist Colliander, Magnus et al. | 2017
- 101
-
On elastic waves in granular assemblies: From a continuumnization viewpointChen, J. / Supprasert, S. / O-tani, H. / Fujita, K. / Wijerathne, L. / Hori, M. et al. | 2017
- 114
-
A finite-deformation-based constitutive model for high-temperature shape-memory alloysSakhaei, Amir Hosein / Thamburaja, Prakash et al. | 2016
- IFC
-
Editorial Board| 2015