Influences of the volume fraction and shape of steel fibers on fiber-reinforced concrete subjected to dynamic loading – A review (Englisch)
- Neue Suche nach: Soufeiani, Leila
- Neue Suche nach: Raman, Sudharshan N.
- Neue Suche nach: Jumaat, Mohd Zamin Bin
- Neue Suche nach: Alengaram, Ubagaram Johnson
- Neue Suche nach: Ghadyani, Ghasem
- Neue Suche nach: Mendis, Priyan
- Neue Suche nach: Soufeiani, Leila
- Neue Suche nach: Raman, Sudharshan N.
- Neue Suche nach: Jumaat, Mohd Zamin Bin
- Neue Suche nach: Alengaram, Ubagaram Johnson
- Neue Suche nach: Ghadyani, Ghasem
- Neue Suche nach: Mendis, Priyan
In:
Engineering Structures
;
124
;
405-417
;
2016
-
ISSN:
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:Influences of the volume fraction and shape of steel fibers on fiber-reinforced concrete subjected to dynamic loading – A review
-
Beteiligte:Soufeiani, Leila ( Autor:in ) / Raman, Sudharshan N. ( Autor:in ) / Jumaat, Mohd Zamin Bin ( Autor:in ) / Alengaram, Ubagaram Johnson ( Autor:in ) / Ghadyani, Ghasem ( Autor:in ) / Mendis, Priyan ( Autor:in )
-
Erschienen in:Engineering Structures ; 124 ; 405-417
-
Verlag:
- Neue Suche nach: Elsevier Ltd
-
Erscheinungsdatum:21.06.2016
-
Format / Umfang:13 pages
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Schlagwörter:
-
Datenquelle:
Inhaltsverzeichnis – Band 124
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 1
-
Effectiveness of distributed tuned mass dampers for multi-mode control of chimney under earthquakesElias, Said / Matsagar, Vasant / Datta, T.K. et al. | 2016
- 17
-
Behavior and design of slender circular tubed-reinforced-concrete columns subjected to eccentric compressionZhou, Xuhong / Liu, Jiepeng / Wang, Xuanding / Chen, Y. Frank et al. | 2016
- 29
-
Strengthening system using post-tension tendon with an internal anchorage of concrete membersMimoto, Tatsuhiko / Sakaki, Takuya / Mihara, Takafumi / Yoshitake, Isamu et al. | 2016
- 36
-
Model reduction and optimal parameters of mid-story isolation systemsZhou, Q. / Singh, M.P. / Huang, X.Y. et al. | 2016
- 49
-
Seismic behaviors of squat reinforced concrete shear walls under freeze-thaw cycles: A pilot experimental studyYang, Wei / Zheng, Shan-Suo / Zhang, De-Yi / Sun, Long-Fei / Gan, Chuan-Lei et al. | 2016
- 64
-
Development of fragility curves for localised pull-through failures of thin steel roof battensSivapathasundaram, Mayooran / Mahendran, Mahen et al. | 2016
- 85
-
Theoretical approach to the evaluation of the load-carrying capacity of the tie rod anchor system in a masonry wallPisani, Marco Andrea et al. | 2016
- 96
-
Exact matching at a joint of multiply-connected box beams under out-of-plane bending and torsionChoi, Soomin / Kim, Yoon Young et al. | 2016
- 113
-
Accidental eccentricities, frame shear forces and ductility demands of buildings with uncertainties of stiffness and live loadDe-la-Colina, Jaime / González-Pérez, Carlos A. / Valdés-González, Jesús et al. | 2016
- 128
-
Slenderness effects in thin-walled I-section struts susceptible to local–global mode interactionBai, Li / Wadee, M. Ahmer et al. | 2016
- 142
-
Mesoscale partitioned analysis of brick-masonry archesZhang, Yanyang / Macorini, Lorenzo / Izzuddin, Bassam A. et al. | 2016
- 167
-
High strength steel in chevron concentrically braced frames designed according to Eurocode 8Tenchini, Andre / D’Aniello, Mario / Rebelo, Carlos / Landolfo, Raffaele / da Silva, Luis Simões / Lima, Luciano et al. | 2016
- 186
-
Modelling the influence of the fibre structure on the structural behaviour of flowable fibre-reinforced concreteSarmiento, E.V. / Hendriks, M.A.N. / Geiker, M.R. / Kanstad, T. et al. | 2016
- 196
-
Rational finite element assisted design of precast steel fibre reinforced concrete pipesMohamed, Nedal / Nehdi, Moncef L. et al. | 2016
- 207
-
An efficient approach to the evaluation of wind effects on structures based on recorded pressure fieldsPatruno, L. / Ricci, M. / de Miranda, S. / Ubertini, F. et al. | 2016
- 221
-
A method for identification of an effective Winkler foundation for large-diameter offshore wind turbine support structures based on in-situ measured small-strain soil response and 3D modellingVersteijlen, W.G. / Metrikine, A.V. / van Dalen, K.N. et al. | 2016
- 237
-
Some remarks on the interaction of long-term effects in deflections of RC membersZanuy, Carlos et al. | 2016
- 245
-
Influence of adjusted models of plastic hinges in nonlinear behaviour of reinforced concrete buildingsLópez-López, Andrés / Tomás, Antonio / Sánchez-Olivares, Gregorio et al. | 2016
- 258
-
Strengthening of non-conforming RC shear walls using different steel configurationsChristidis, Konstantinos I. / Vougioukas, Emmanouil / Trezos, Konstantinos G. et al. | 2016
- 269
-
Mechanical behavior and size effect of moderate high-strength RC columns under monotonic and cyclic axial compressionJin, Liu / Li, Dong / Du, Xiuli et al. | 2016
- 286
-
Developing a new hysteretic type seismic damper (BRRP) for steel bridgesYamazaki, Shinsuke / Usami, Tsutomu / Nonaka, Tetsuya et al. | 2016
- 302
-
Finite element modeling of the composite action between hollowcore slabs and the topping concreteAdawi, Aiham / Youssef, Maged A. / Meshaly, Mohamed E. et al. | 2016
- 316
-
Theoretical model of adhesively bonded single lap joints with functionally graded adherendsGuin, William E. / Wang, Jialai et al. | 2016
- 333
-
Topology optimization for simplified structural fire safetyMadsen, Søren / Lange, Nis P. / Giuliani, Luisa / Jomaas, Grunde / Lazarov, Boyan S. / Sigmund, Ole et al. | 2016
- 344
-
Semi-implicit finite strain constitutive integration and mixed strain/stress control based on intermediate configurationsAreias, P. / Rabczuk, T. / César de Sá, J. / Alves, J.L. et al. | 2016
- 361
-
Numerical study on reducing building vibrations by foundation improvementPersson, P. / Persson, K. / Sandberg, G. et al. | 2016
- 376
-
Integrated analysis of kinematic form active structures for architectural applications: Design of a representative case studyPuystiens, Silke / Van Craenenbroeck, Maarten / De Laet, Lars / Van Hemelrijck, Danny / Van Paepegem, Wim / Mollaert, Marijke et al. | 2016
- 388
-
Effect of thermal induced flexural strain cycles on the low cycle fatigue performance of integral bridge steel H-pilesKaralar, Memduh / Dicleli, Murat et al. | 2016
- 405
-
Influences of the volume fraction and shape of steel fibers on fiber-reinforced concrete subjected to dynamic loading – A reviewSoufeiani, Leila / Raman, Sudharshan N. / Jumaat, Mohd Zamin Bin / Alengaram, Ubagaram Johnson / Ghadyani, Ghasem / Mendis, Priyan et al. | 2016
- 418
-
Effect of arrangement of tensile reinforcement on flexural stiffness and crackingGribniak, Viktor / Pérez Caldentey, Alejandro / Kaklauskas, Gintaris / Rimkus, Arvydas / Sokolov, Aleksandr et al. | 2016
- 429
-
Structural integrity of corroded girth welds in vintage steel pipelinesHertelé, Stijn / Cosham, Andrew / Roovers, Paul et al. | 2016
- 442
-
Improvement of the model proposed by Menegotto and Pinto for steelBosco, M. / Ferrara, E. / Ghersi, A. / Marino, E.M. / Rossi, P.P. et al. | 2016
- 457
-
Effective stress-strain relationships for analysis of noncompact and slender filled composite (CFT) membersLai, Zhichao / Varma, Amit H. et al. | 2016
- 473
-
Structural stability analysis of single-layer reticulated shells with stochastic imperfectionsLiu, Huijuan / Zhang, Wei / Yuan, Hao et al. | 2016
- 480
-
Deformation capacity of non-conforming r.c. columns under compressive axial load and biaxial bendingDel Zoppo, Marta / Di Ludovico, Marco / Prota, Andrea et al. | 2016
- 494
-
Deck–tower interaction in the transverse seismic response of cable-stayed bridges and optimum configurationsCamara, A. / Efthymiou, E. et al. | 2016
- 507
-
Seismic design of bridge columns incorporating mechanical bar splices in plastic hinge regionsTazarv, Mostafa / Saiidi, M. Saiid et al. | 2016
- 521
-
A nonlinear quadrilateral layered membrane element with drilling degrees of freedom for the modeling of reinforced concrete wallsRojas, F. / Anderson, J.C. / Massone, L.M. et al. | 2016
- 539
-
Wind tunnel tests of two free-standing lighting protection masts in different arrangements with surroundings roof objects and roof conditionsFlaga, Andrzej / Kłaput, Renata / Augustyn, Marcin et al. | 2016
- IFC
-
Editorial Board| 2016