Evaluation of Additive Manufacturing Techniques Applied to a Waveguide Mode Transducer (Englisch)
- Neue Suche nach: Montejo-Garai, Jose R.
- Weitere Informationen zu Montejo-Garai, Jose R.:
- https://orcid.org/0000-0002-3535-3055
- Neue Suche nach: Ruiz-Cruz, Jorge A.
- Weitere Informationen zu Ruiz-Cruz, Jorge A.:
- https://orcid.org/0000-0003-3909-8263
- Neue Suche nach: Rebollar, Jesus M.
- Neue Suche nach: Montejo-Garai, Jose R.
- Weitere Informationen zu Montejo-Garai, Jose R.:
- https://orcid.org/0000-0002-3535-3055
- Neue Suche nach: Ruiz-Cruz, Jorge A.
- Weitere Informationen zu Ruiz-Cruz, Jorge A.:
- https://orcid.org/0000-0003-3909-8263
- Neue Suche nach: Rebollar, Jesus M.
In:
IEEE Transactions on Components, Packaging and Manufacturing Technology
;
10
, 5
;
887-894
;
2020
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:Evaluation of Additive Manufacturing Techniques Applied to a Waveguide Mode Transducer
-
Beteiligte:Montejo-Garai, Jose R. ( Autor:in ) / Ruiz-Cruz, Jorge A. ( Autor:in ) / Rebollar, Jesus M. ( Autor:in )
-
Erschienen in:IEEE Transactions on Components, Packaging and Manufacturing Technology ; 10, 5 ; 887-894
-
Verlag:
- Neue Suche nach: IEEE
-
Erscheinungsdatum:01.05.2020
-
Format / Umfang:3424111 byte
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Datenquelle:
Inhaltsverzeichnis – Band 10, Ausgabe 5
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 739
-
Table of contents| 2020
- 741
-
Investigation Into How the Floor Plan Layout of a Manufactured PCB Influences Flip-Chip Susceptibility to VibrationBaishya, Kangkana / Harvey, David Mark / Zhang, Guangming / Braden, Derek Richard et al. | 2020
- 749
-
Accurate Modeling of the Capacitance of Through-Silicon Via Considering Minority Carrier EffectsLiu, Huan / Fang, Runiu / Miao, Min / Jin, Yufeng et al. | 2020
- 763
-
Evaluation of Launderability of Electrically Conductive Fabrics for E-Textile ApplicationsLiu, Weifeng / Shangguan, Dongkai / Lee, Jeffrey ChangBing et al. | 2020
- 770
-
Bond Strength and Failure Mechanisms of Nonconductive Adhesives for Stretchable ElectronicsSalo, Teemu / Halme, Aki / Kanerva, Mikko / Vanhala, Jukka et al. | 2020
- 779
-
MEMS Chip With Amplifier for 4-W Power Combining up to 100 GHzCheng, Haifeng / Hou, Fang / Guo, Jian / Wang, Weibo / Hu, Sanming et al. | 2020
- 786
-
A Dynamic Control System for Server Processor Direct Liquid CoolingChen, Haoran / Han, Yong / Tang, Gongyue / Zhang, Xiaowu et al. | 2020
- 795
-
A Novel Approach to Control of Piezo-Transducer in Microelectronics Packaging: PSO-PID and Editing Trajectory OptimizationLong, Zhili / Jiang, Zhaotian / Wang, Chao / Jin, Yan / Cao, Zhonghua / Li, Yangmin et al. | 2020
- 806
-
Mechanical and Electrical Behavior of Printed Silver Conductor in Adaptive Curvature Flexure TestChen, Rui / Chow, Justin H. / Taylor, Christine / Meth, Jeffrey / Sitaraman, Suresh K. et al. | 2020
- 817
-
Optimization of Converging and Diverging Microchannel Heat Sink for Electronic Chip CoolingAlugoju, Uday Kumar / Dubey, Satish Kumar / Javed, Arshad et al. | 2020
- 828
-
Effect of Solder Paste Volume and Reflow Parameters on Solder Paste Wicking and Joint Shear Strength of Ni–Au-Coated Cu SpheresGupte, Omkar / Murtagian, Gregorio / Tummala, Rao / Smet, Vanessa et al. | 2020
- 836
-
A Comprehensive Review of the Finite Element Modeling of Electrical Connectors Including Their ContactsAngadi, Santosh V. / Jackson, Robert L. / Pujar, Vijayakumar / Tushar, M. R. et al. | 2020
- 845
-
Influence of Operation Numbers on Arc Erosion of Ag/CdO Electrical Contact MaterialsWu, Qiong / Xu, Guofu / Yuan, Meng / Wu, Chunping et al. | 2020
- 858
-
Signal Integrity Design and Analysis of 3-D X-Point Memory Considering Crosstalk and IR Drop for Higher Performance ComputingSon, Kyungjune / Cho, Kyungjun / Kim, Subin / Park, Shinyoung / Jung, Daniel H. / Park, Junyong / Park, Gapyeol / Kim, Seongguk / Shin, Taein / Kim, Youngwoo et al. | 2020
- 870
-
Low-Loss Impedance-Matched Sub-25-μm Vias in 3-D Millimeter-Wave PackagesWatanabe, Atom O. / Ito, Hirokazu / Markondeya, Raj Pulugurtha / Tummala, Rao R. / Swaminathan, Madhavan et al. | 2020
- 878
-
Compact Fractional-Order Model of On-Chip Inductors With BCB on High Resistivity SiliconShi, Liyun / Yuan, Yang / Gao, Jianjun / Zhou, Liang / Mao, Junfa et al. | 2020
- 887
-
Evaluation of Additive Manufacturing Techniques Applied to a Waveguide Mode TransducerMontejo-Garai, Jose R. / Ruiz-Cruz, Jorge A. / Rebollar, Jesus M. et al. | 2020
- 895
-
Open Defect Detection Not Utilizing Boundary Scan Flip-Flops in Assembled Circuit BoardsKanda, Michiya / Hashizume, Masaki / Binti ALI, Fara Ashikin / Yotsuyanagi, Hiroyuki / Lu, Shyue-Kung et al. | 2020
- 908
-
A Low-Temperature Nickel Silicide Process for Wafer Bonding and High-Density InterconnectsSmith, Melissa A. / Holihan, Eric / Duncan, Bradley P. / McRae, James C. / Miller, Paul / Stull, Corey / Pinelli, Gianni / Yost, Donna-Ruth Webb / Racz, Livia M. et al. | 2020
- 917
-
A Study of Low-Cost Sequential Electroplating Bumping Process and its Metallurgical BehaviorEl Amrani, Abderrahim / Paradis, Etienne / Danovitch, David / Drouin, Dominique et al. | 2020
- 924
-
Effect of the Curing Properties and Viscosities of Nonconductive Films on the Solder Joint Morphology and Reliability of Chip-On-Board Packages Using Cu-Pillar/Sn–Ag BumpsLee, HanMin / Lee, SeYong / Choi, TaeJin / Park, SooIn / Ko, Eun Kyoung / Paik, Kyung-Wook et al. | 2020
- 931
-
Member Get-A-Member (MGM) Program| 2020
- C1
-
Front Cover| 2020
- C2
-
IEEE Transactions on Components, Packaging and Manufacturing Technology publication information| 2020
- C3
-
IEEE Components, Packaging, and Manufacturing Technology Society information for authors| 2020
- C4
-
IEEE Components, Packaging, and Manufacturing Technology Society Information| 2020