Jam Detector for Steel Pickling Lines Using Machine Vision (Englisch)
- Neue Suche nach: Usamentiaga, Ruben
- Neue Suche nach: Molleda, Julio
- Neue Suche nach: Garcia, Daniel F.
- Neue Suche nach: Bulnes, Francisco G.
- Neue Suche nach: Perez, Jesus M.
- Neue Suche nach: Usamentiaga, Ruben
- Neue Suche nach: Molleda, Julio
- Neue Suche nach: Garcia, Daniel F.
- Neue Suche nach: Bulnes, Francisco G.
- Neue Suche nach: Perez, Jesus M.
In:
IEEE Transactions on Industry Applications
;
49
, 5
;
1954-1961
;
2013
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:Jam Detector for Steel Pickling Lines Using Machine Vision
-
Beteiligte:Usamentiaga, Ruben ( Autor:in ) / Molleda, Julio ( Autor:in ) / Garcia, Daniel F. ( Autor:in ) / Bulnes, Francisco G. ( Autor:in ) / Perez, Jesus M. ( Autor:in )
-
Erschienen in:IEEE Transactions on Industry Applications ; 49, 5 ; 1954-1961
-
Verlag:
- Neue Suche nach: IEEE
-
Erscheinungsdatum:01.09.2013
-
Format / Umfang:1044756 byte
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Datenquelle:
Inhaltsverzeichnis – Band 49, Ausgabe 5
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 1939
-
Comparing International Standards to North American Standards for Large Adjustable-Speed DrivesPhares, Douglas / Verma, Manish / Horvath, Bill / Rodgers, Nathan et al. | 2013
- 1946
-
Online Realizations of Dynamic Gap Detection and Control for Levitated Industrial Steel-Plate Conveyance SystemLiu, Cheng-Tsung / Yang, Yung-Yi / Lin, Sheng-Yang et al. | 2013
- 1954
-
Jam Detector for Steel Pickling Lines Using Machine VisionUsamentiaga, Ruben / Molleda, Julio / Garcia, Daniel F. / Bulnes, Francisco G. / Perez, Jesus M. et al. | 2013
- 1962
-
Improvement in Control of the Tandem Hot Strip MillPittner, John / Simaan, Marwan A. et al. | 2013
- 1971
-
Innovative Differential Protection of Power Transformers Using Low-Energy Current SensorsKojovic, Ljubomir A. / Bishop, Martin T. / Sharma, Dharam et al. | 2013
- 1979
-
Measurements and Modeling of Through-the-Earth Communications for Coal MinesYan, Lincan / Waynert, Joseph A. / Sunderman, Carl et al. | 2013
- 1984
-
Measurements of Medium-Frequency Propagation Characteristics of a Transmission Line in an Underground Coal MineLi, Jingcheng / Whisner, Bruce / Waynert, Joseph A. et al. | 2013
- 1992
-
Evaluation of Visual Performance When Using Incandescent, Fluorescent, and LED Machine Lights in Mesopic ConditionsReyes, Miguel Angel / Gallagher, Sean / Sammarco, John J. et al. | 2013
- 2000
-
Protection of Large Power ConvertersGalloway, James H. / Buddingh, Paul C. et al. | 2013
- 2006
-
Facing Today's Installation Challenges of Adjustable-Speed Drives for Controlling Motors in Hazardous Location AreasSundlov, Steven P. / Manahan, Joseph M. / Potter, Robert C. / Cary, Stephen M. / Holub, Richard A. et al. | 2013
- 2015
-
Relationship Between Rotor Losses and Size of Permanent-Magnet MachinesBianchi, Nicola / Durello, Dario / Fasolo, Alessandro et al. | 2013
- 2024
-
Evaluation of the Influence of Rotor Axial Air Ducts on Condition Monitoring of Induction MotorsLee, Sungho / Hong, Jongman / Lee, Sang Bin / Wiedenbrug, Ernesto J. / Teska, Mike / Kim, Heedong et al. | 2013
- 2034
-
Integrated Generator for More Electric Engine: Design and Testing of a Scaled-Size PrototypeCavagnino, Andrea / Li, Zijian / Tenconi, Alberto / Vaschetto, Silvio et al. | 2013
- 2044
-
Three-Dimensional Eddy-Current Analysis in Steel Laminations of Electrical Machines as a Contribution for Improved Iron Loss ModelingHandgruber, Paul / Stermecki, Andrej / Biro, Oszkar / Belahcen, Anouar / Dlala, Emad et al. | 2013
- 2053
-
Design and Optimization of A Blood Pump for A Wearable Artificial Kidney DeviceMarkovic, Miroslav / Rapin, Michael / Correvon, Marc / Perriard, Yves et al. | 2013
- 2061
-
Core Loss Prediction in Electrical Machine Laminations Considering Skin Effect and Minor Hysteresis LoopsIbrahim, Maged / Pillay, Pragasen et al. | 2013
- 2069
-
Estimation of the Magnetic Properties of the Damaged Area Resulting From the Punching Process: Experimental Research and FEM ModelingGmyrek, Zbigniew / Cavagnino, Andrea / Ferraris, Luca et al. | 2013
- 2078
-
Thermal Model and Analysis of Wound-Rotor Induction MachineBoglietti, Aldo / Cavagnino, Andrea / Popescu, Mircea / Staton, Dave et al. | 2013
- 2086
-
Automated Multi-Objective Design Optimization of PM AC Machines Using Computationally Efficient FEA and Differential EvolutionSizov, Gennadi Y. / Zhang, Peng / Ionel, Dan M. / Demerdash, Nabeel A. O. / Rosu, Marius et al. | 2013
- 2097
-
A Novel and Fundamental Approach Toward Field and Damper Circuit Parameter Determination of Synchronous MachineMukherjee, Kaushik / Iyer, K. Lakshmi Varaha / Lu, Xiaomin / Kar, Narayan C. et al. | 2013
- 2106
-
Design and Characterization of a Three-Phase Brushless Exciter for Aircraft Starter/GeneratorGriffo, Antonio / Wrobel, Rafal / Mellor, Phil H. / Yon, Jason M. et al. | 2013
- 2116
-
Experimental Identification of the Magnetic Model of Synchronous MachinesArmando, Eric / Bojoi, Radu Iustin / Guglielmi, Paolo / Pellegrino, Gianmario / Pastorelli, Michele et al. | 2013
- 2126
-
Deadlock Avoidance in Model Predictive Direct Torque ControlBurtscher, Thomas / Geyer, Tobias et al. | 2013
- 2136
-
Online Identification of Parameters Defining the Saturation Characteristics of Induction MachinesRanta, Mikaela / Hinkkanen, Marko et al. | 2013
- 2146
-
Model Predictive Direct Torque Control: Derivation and Analysis of the State-Feedback Control LawGeyer, Tobias et al. | 2013
- 2158
-
Single-Phase Semi-Bridge Five-Level Flying-Capacitor RectifierTeixeira, Carlos Alberto / Holmes, Donald Grahame / McGrath, Brendan P. et al. | 2013
- 2167
-
Benchmarking of Grid Fault Modes in Single-Phase Grid-Connected Photovoltaic SystemsYang, Yongheng / Blaabjerg, Frede / Zou, Zhixiang et al. | 2013
- 2177
-
Magnetically Coupled Impedance-Source InvertersLoh, Poh Chiang / Blaabjerg, Frede et al. | 2013
- 2188
-
Distributed Operation of Interlinked AC Microgrids with Dynamic Active and Reactive Power TuningNutkani, Inam Ullah / Loh, Poh Chiang / Blaabjerg, Frede et al. | 2013
- 2197
-
Doubly Fed Induction Generator in an Offshore Wind Power Plant Operated at Rated V/HzMuljadi, Eduard / Singh, Mohit / Gevorgian, Vahan et al. | 2013
- 2206
-
Damper Windings in Induction Machines for Reduction of Unbalanced Magnetic Pull and Bearing WearDorrell, David G. / Shek, Jonathan K. H. / Mueller, Markus A. / Hsieh, Min-Fu et al. | 2013
- 2217
-
A Multiport AC Link PV Inverter With Reduced Size and Weight for Stand-Alone ApplicationAmirabadi, Mahshid / Toliyat, Hamid A. / Alexander, William C. et al. | 2013
- 2229
-
Particle-Swarm-Optimization-Based Nonintrusive Demand Monitoring and Load Identification in Smart MetersChang, Hsueh-Hsien / Lin, Lung-Shu / Chen, Nanming / Lee, Wei-Jen et al. | 2013
- 2237
-
Development of Frequency Variable Inverter Based on SOPC and Nios IILiu, He-Jin / Li, Ke-Jun / Lee, Wei-Jen / Gao, Hongxia / Sun, Ying et al. | 2013
- 2244
-
A Discrete Point Estimate Method for Probabilistic Load Flow Based on the Measured Data of Wind PowerAi, Xiaomeng / Wen, Jinyu / Wu, Tong / Lee, Wei-Jen et al. | 2013
- 2253
-
A Novel Hybrid Approach Based on Wavelet Transform and Fuzzy ARTMAP Networks for Predicting Wind Farm Power ProductionHaque, Ashraf Ul / Mandal, Paras / Meng, Julian / Srivastava, Anurag K. / Tseng, Tzu-Liang / Senjyu, Tomonobu et al. | 2013
- 2262
-
Optimal Placement and Sizing of Multiple DGs in a Practical Distribution System by Considering Power LossLee, Soo Hyoung / Park, Jung-Wook et al. | 2013
- 2271
-
Nonlinear Parameter Optimization of FACTS Controller via Real-Time Digital SimulatorBaek, Seung-Mook / Park, Jung-Wook et al. | 2013
- 2279
-
Practical Experiences and Mitigation Methods of Harmonics in Wind Power PlantsBadrzadeh, Babak / Gupta, Manoj et al. | 2013
- 2290
-
Numerical Simulation of Heart-Current Factors and Electrical Models of the Human BodyFreschi, Fabio / Guerrisi, Alessandra / Tartaglia, Michele / Mitolo, Massimo et al. | 2013
- 2300
-
Variation in Static Decay Time With Surface ResistivityRobinson, Kelly S. et al. | 2013
- 2308
-
Study on Surface Modification of GaN by Atmospheric MicroplasmaShimizu, Kazuo / Noma, Yuta / Blajan, Marius / Naritsuka, Shigeya et al. | 2013
- 2314
-
Velocity and Turbulence Intensity of an EHD Impinging Dielectric Liquid Jet in Blade–Plane GeometryYan, Zelu / Louste, Christophe / Traore, Philippe / Romat, Hubert et al. | 2013
- 2323
-
Optimal Control of a High-Voltage Power Supply Based on the PRC-LCC Topology With a Capacitor as Output FilterMartin-Ramos, Juan A. / Villegas Saiz, Pedro Jose / Pernia, Alberto M. / Diaz, Juan / Martinez, Juan A. et al. | 2013
- 2330
-
“SRF Theory Revisited” to Control Self-Supported Dynamic Voltage Restorer (DVR) for Unbalanced and Nonlinear LoadsKanjiya, Parag / Singh, Bhim / Chandra, Ambrish / Al-Haddad, Kamal et al. | 2013
- 2341
-
A Novel Wavelet-Neural-Network-Based Robust Controller for IPM Motor DrivesKhan, M. Abdesh / Uddin, M. Nasir / Rahman, M. Azizur et al. | 2013
- 2352
-
Active Stabilization of DC Microgrids Without Remote Sensors for More Electric AircraftMagne, Pierre / Nahid-Mobarakeh, Babak / Pierfederici, Serge et al. | 2013
- 2361
-
Light Emission of Electroluminescent Lamps Under Different Operating ConditionsKaiser, Walter / Marques, Ricardo Paulino / Correa, Alexander Fernandez et al. | 2013
- 2370
-
Do what you do better with What's New @ IEEE Xplore| 2013
- 2371
-
myIEEE| 2013
- 2372
-
Together, we are advancing technology| 2013
- C1
-
Table of contents| 2013
- C2
-
IEEE Transactions on Industry Applications publication information| 2013
- C3
-
IEEE Industry Applications Society Information| 2013
- C4
-
IEEE Transactions on Industry Applications information for authors| 2013