New results on the relationship between hardness and fracture toughness and WC-Co hardmetal (Englisch)
- Neue Suche nach: O'Quigley, D.G.F.
- Neue Suche nach: Luyckx, S.
- Neue Suche nach: James, M.N.
- Neue Suche nach: O'Quigley, D.G.F.
- Neue Suche nach: Luyckx, S.
- Neue Suche nach: James, M.N.
In:
Materials Science and Engineering, Part A (Structural Materials: Properties, Microstructure and Processing)
;
209
, 1-2
;
228-230
;
1996
-
ISSN:
- Aufsatz (Zeitschrift) / Print
-
Titel:New results on the relationship between hardness and fracture toughness and WC-Co hardmetal
-
Weitere Titelangaben:Neue Erkenntnisse über die Beziehung zwischen Härte und Bruchzähigkeit von WC-Co-Hartmetall
-
Beteiligte:
-
Erschienen in:
-
Verlag:
-
Erscheinungsdatum:1996
-
Format / Umfang:3 Seiten, 1 Bild, 6 Quellen
-
ISSN:
-
Coden:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Print
-
Sprache:Englisch
-
Schlagwörter:
-
Datenquelle:
Inhaltsverzeichnis – Band 209, Ausgabe 1-2
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 1
-
Structural, electronic and optical properties of carbon nitrideCohen, M.L. et al. | 1996
- 5
-
Phases and physical properties of carbon nitride thin films prepared by pulsed laser depositionZhang, Z.J. et al. | 1996
- 10
-
Synthesis of carbon nitride thin films by vacuum arcsHusein, I.F. et al. | 1996
- 16
-
Superhard boron-rich borides and studies of the B-C-N systemLundström, T. et al. | 1996
- 23
-
Initial description of a new carbon-nitride phase synthesized at high pressures and temperaturesNguyen, J.H. et al. | 1996
- 26
-
Characterizations of several cubic phases directly transformed from the graphitic BC~2NNakano, S. / Akaishi, M. / Sasaki, T. / Yamaoka, S. et al. | 1996
- 26
-
Characterizations of several cubic phases directly transformed from the graphic BC2NNakano, S. et al. | 1996
- 30
-
A study of interface binding theoryShen, Z.T. et al. | 1996
- 33
-
Crystal growth of vanadium silicides from high-temperature metal solutions and some properties of the crystalsOkada, S. et al. | 1996
- 38
-
Friction and wear properties of as-deposited and carbon ion-implanted diamond filmsMiyoshi, K. et al. | 1996
- 54
-
Physical and chemical properties of the heat resistant diamond compacts from diamond-magnesium carbonate systemAkaishi, M. et al. | 1996
- 60
-
Frictional characteristics of diamond sliding on as-grown surfaces of large GEM quality single crystal synthetic diamondLee, M. et al. | 1996
- 68
-
Enhancement of heat dissipation in well-faceted (100) diamond thin filmKim, S.H. et al. | 1996
- 74
-
Physical chemistry of intrinsic hardnessGilman, J.J. et al. | 1996
- 82
-
Modelling of interfacial fractureRabinovich, V.L. et al. | 1996
- 91
-
Elastic, plastic and cracking indentation behavior of silicon crystalsArmstrong, R.W. et al. | 1996
- 97
-
Plastic deformation of silicon nitride single crystalsSuematsu, H. et al. | 1996
- 103
-
Microstructural processes during subcritical crack growth in hard metals and cermets under cyclic loadsSchleinkofer, U. et al. | 1996
- 111
-
High-temperature deformation of ZrO2-Al2O3-SiC whisker composites fabricated by two techniquesMoreno, J.M.Calderon et al. | 1996
- 116
-
The measurement of surface contact fatigue and its application to engineering ceramicsGuillou, M.-O. et al. | 1996
- 128
-
Constituent phase nanoindentation of WC-Co and Ti(C,N) hard metalsGee, M.G. et al. | 1996
- 137
-
Elevated temperature fracture behavior of monolithic and SiCw-reinforced silicon nitride under quasi-static loadsHansson, T. et al. | 1996
- 149
-
Microstructure, permeability and mechanical behaviour of ceramic foamsLopes, R.A. et al. | 1996
- 156
-
Improved hardness and hierarchic influences on wear in submicron sintered aluminaKrell, A. et al. | 1996
- 164
-
Effect of iron and silicon addition on the densification, microstructure and mechanical properties of silicon nitrideDuailibi Fh, J. et al. | 1996
- 169
-
Relation between fracture surface area of a flexural strength specimen and fracture toughness for WC-10mass%Co cemented carbide and Si3N4 ceramicsYanaba, Y. et al. | 1996
- 175
-
Mechanical properties of SialonSilva, C.R.M.da et al. | 1996
- 180
-
Electrochemical behaviour of tungsten-carbide hardmetalsHuman, A.M. et al. | 1996
- 192
-
Formation of stratified binder phase gradientsGustafson, P. et al. | 1996
- 197
-
Residual stress in WC-Co measured by neutron diffractionMari, D. et al. | 1996
- 206
-
Oxidation behavior of WC-CoBasu, S.N. et al. | 1996
- 213
-
Microstructural evolution during the sintering of a Ti(C,N)- Mo2C-Ni alloyYang, J.K. et al. | 1996
- 218
-
Microstructure and high temperature mechanical properties of TiC0.7N0.3-Mo2C-Ni cementsCutard, T. et al. | 1996
- 218
-
Microstructure and high temperature mechanical properties of TiC~0~.~7N~0~.~3-Mo~2C-Ni cermetsCutard, T. / Viatte, T. / Feusier, G. / Benoit, W. et al. | 1996
- 228
-
New results on the relationship between hardness and fracture toughness and WC-Co hardmetalO'Quigley, D.G.F. / Luyckx, S. / James, M.N. et al. | 1996
- 228
-
New results on the relationship between hardness and fracture toughness of WC-Co hardmetalO'Quigley, D.G.F. et al. | 1996
- 231
-
Microstructure of spray converted nanostructured tungsten carbide-cobalt compositeMohan, K. et al. | 1996
- 231
-
The influence of rare earth on Co-based alloyWu, Y. et al. | 1996
- 243
-
Ceramic composites with a ductile Ni3Al binder phaseTiegs, T.N. et al. | 1996
- 248
-
Effects of high-temperature environments on flaw generation and fracture behavior of SiC-SiC compositesSingh, J.P. et al. | 1996
- 251
-
A microstructural investigation of the mechanisms of tensile creep deformation in an Al2O3-SiCw compositeO'Meara, C. et al. | 1996
- 260
-
Cutting performance of sintered diamond with MgCO3 as a sintering agentUeda, F. et al. | 1996
- 264
-
Tribology of diamond-like carbon coated VCR head drumsLee, K.-R. et al. | 1996
- 270
-
Fracture toughness and thermal resistance of polycrystalline diamond compactsMiess, D. et al. | 1996
- 277
-
Tribological properties of AlN-CeO2-Si3N4 cutting materials in unlubricated sliding against tool steel and cast ironGomes, J.R. et al. | 1996
- 287
-
Application of rare earth elements in cemented carbide inserts, drawing dies and mining toolsJi, X. et al. | 1996
- 294
-
The influence of TiN content on properties of Ti(CN) solid solutionShangzhi, X. et al. | 1996
- 298
-
A study on the formation of anomalous large WC grain and the eta phaseCho, K.H. et al. | 1996
- 302
-
High pressure synthetic diamond: Optical studies of nickel related defectsNazare, M.H. et al. | 1996
- 306
-
Some issues in Ti(CN)-WC-TaC cermetsKang, S. et al. | 1996
- 313
-
Fatigue of hard metals and cermetsSchleinkofer, U. et al. | 1996
- 318
-
Thermal residual stress distribution in WC-Ni compositesWeisbrook, C.M. et al. | 1996
- 329
-
Indentation hardness and fracture toughness in single crystal TiC0.96Maerky, C. et al. | 1996
- 337
-
Microstructure and performance of CVD k-Al2O3 multilayersHalvarsson, M. et al. | 1996
- 337
-
Microstructure and performance of CVD kappa-Al~2O~3 multilayersHalvarsson, M. / Vuorinen, S. et al. | 1996
- 345
-
Synthesis of TiN and TiN~xC~y: optimization of reaction parametersShaviv, R. et al. | 1996
- 345
-
Synthesis of TiN and TiNxCv: Optimization of reaction parametersShaviv, R. et al. | 1996
- 353
-
Characterisation and wear behaviour of TiN- and TiCx N1-x-coated cermetsRichter, V. et al. | 1996
- 358
-
Miniaturised thermomechanical tests on hardmetals and cermetsRoebuck, B. et al. | 1996
- 366
-
Advances and development in CVD technologyHintermann, H.E. et al. | 1996
- 372
-
Preparation and friction characteristics of self-lubricating TiN-MoS2 composite coatingsBae, Y.W. et al. | 1996
- 377
-
Towards closed-loop control of CVD coating microstructureGevelber, M. et al. | 1996
- 384
-
Composite CVD + PVD coatingsGodse, R.V. et al. | 1996
- 389
-
Influence of different hydrocarbons on the structure of CVD- and PACVD-TiCx hard layersLeonhardt, A. et al. | 1996
- 394
-
Superstoichiometric PVD carbide coatingsKnotek, O. et al. | 1996
- 399
-
Effect of additional gas on diamond deposition by DC PACVDLee, J.-K. et al. | 1996
- 405
-
CVD diamond coated cemented carbide cutting toolsKarner, J. et al. | 1996
- 414
-
Enhancement of diamond thin film quality by a cyclic deposition method under MPECVDPark, Y.S. et al. | 1996
- 421
-
Author Index| 1996
- 423
-
Subject Index| 1996