Study about the Vehicle Orientation on the Trajectory during Transient Movements (Englisch)
Nationallizenz
- Neue Suche nach: Bolcu, Dumitru
- Neue Suche nach: Stănescu, Marius Marinel
- Neue Suche nach: Miriţoiu, Cosmin Mihai
- Neue Suche nach: Burada, Cristian Oliviu
In:
Applied Mechanics and Materials
;
822
;
68-73
;
2016
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:Study about the Vehicle Orientation on the Trajectory during Transient Movements
-
Beteiligte:
-
Erschienen in:Applied Mechanics and Materials ; 822 ; 68-73
-
Verlag:
- Neue Suche nach: Trans Tech Publications
-
Erscheinungsort:Stafa-Zurich, Switzerland
-
Erscheinungsdatum:12.01.2016
-
Format / Umfang:6 pages
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Schlagwörter:
-
Datenquelle:
Inhaltsverzeichnis – Band 822
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 3
-
Application of Homotopy Analysis Method for Solving Equation of Vehicle’s Move in the Linear Case| 2016
- -4
-
Preface, Committees, Partners and Sponsors| 2016
- 12
-
Car Jack Based on 6R Overconstrained Mechanism| 2016
- 18
-
Design Approach for the Vehicle's Steering Linkage Fitted on Rigid Axle| 2016
- 26
-
Modal-Dynamic Analysis of the Steering Mechanism on a Vehicle| 2016
- 36
-
Theoretical and Experimental Researches Regarding the Influence of the Suspension Car Stiffness on the Dynamic Behavior of Vehicles| 2016
- 44
-
Virtual Model Used for Kinematics Study of Car’s Rear Axle| 2016
- 50
-
Study on the Applied Tolerances Using Computer Aided Design| 2016
- 54
-
Mathematic Model for Analysing the Dynamic Behavior of a Vehicle in the Field of Chaotic Movements| 2016
- 60
-
Design of a Transmission for Wheelchairs Intended to Humans with Locomotors Disabilities| 2016
- 68
-
Study about the Vehicle Orientation on the Trajectory during Transient Movements| 2016
- 74
-
The Theory of Sonics and its Applications in the Automotive Engineering - Part I: Systematization of the Theory of Sonics| 2016
- 83
-
The Modal Analysis for the Helicoidally Spring of the Macpherson Automotive Suspension| 2016
- 89
-
Tester for Study the Influence of Tire Vertical Load and Tire Internal Pressure on Tire Cornering Stiffness| 2016
- 94
-
The Study of the New Type of Trim Corrector Efficiency, Based the Tests on Rigs and on Vehicle| 2016
- 100
-
Studies on the Behavior of the Towbars in Static Applications| 2016
- 112
-
An Approach Regarding Windshield Wiper Mechanism Design| 2016
- 118
-
Solution for Improvement the Thermal Comfort inside the Automobile Passenger Compartment| 2016
- 123
-
Design Optimization of the Diaphragm Spring of a Mechanical Clutch for Motor Cars| 2016
- 135
-
Studies about Reflected Temperature Variation for the Car Brake Disc| 2016
- 141
-
System Heating Using Convection of Mechanical Power through Sonique and Ultrasonique Waves| 2016
- 146
-
F.E.M. Parametric Model Optimization of SERB-194C Device Used in Buildings Drift Limitation System| 2016
- 150
-
Development of a Three-Dimensional Finite Element Knee Prosthesis Model| 2016
- 156
-
The Comparison between Viscous Fluid Dampers and Romanian Friction Dampers Performance in Base Isolation System of Buildings| 2016
- 160
-
Virtual Methods Applied to Human Bones and Joints Re-Construction Used for Orthopedic Systems| 2016
- 169
-
Different Approaches for Determination of Internal Combustion Engines Performances| 2016
- 175
-
A Method of Performing the Supercharging Process at the Engines Researched on the Test Bench| 2016
- 183
-
The Influence of Butanol Use on the Diesel Engine’s Performance| 2016
- 190
-
Theoretical and Experimental Researches Regard the Use of Bioethanol at the Supercharged Spark Ignition Engine| 2016
- 198
-
Theoretical and Experimental Study of the Fuelling a Truck Diesel Engine with Liquefied Petroleum Gas| 2016
- 206
-
The Calculation of the Injection Process for a SI Engine with Electromagnetic Injectors| 2016
- 213
-
Algorithm and Method for the Functional Parameters Determination of Vehicles Engines Mufflers| 2016
- 219
-
Cold Engine’s Operating Regime Influence over the Exhaust Emissions| 2016
- 224
-
Experimental Investigation on Functional Parameters of the Engines Exhaust Mufflers| 2016
- 230
-
Opportunities, Challenges and Future Prospects of Production and Usage of Jatropha Biodiesel as Road Transport Fuel in Romania| 2016
- 235
-
Research Aiming Simultaneously Recycling of Waste Polyolefins by Pyrolysis, in Order to Obtain Some Fuels for Compression Ignition Engines| 2016
- 243
-
Validation of Heat Dissipation Processes in Direct Injection Diesel Engines Air Cooled| 2016
- 252
-
Modeling and Diagnosis of a Powertrain through Specific Parameters| 2016
- 261
-
Analysis of a Railcar Engine Damages Using Forensic Investigation| 2016
- 272
-
Numerical Investigation of Hybrid Electric Vehicle’s Performance| 2016
- 285
-
Running Speeds Determination for Tractor U-650 Equipped with Additional Transmission| 2016
- 293
-
Design of a Wheelchair Intended to Humans with Locomotors Disabilities| 2016
- 299
-
Variation of Start Acceleration for Wheeled and Tracked Autonomous Mini-Vehicles| 2016
- 305
-
The Calculation of the Pressure Losses in the Hydraulic Circuit of a Single Regime Operating Thermal-Hydraulic Generator| 2016
- 311
-
Modelling and Control of a Mobile Robot, Equipped with an Arm in Cylindrical Coordinates with Uncoupled Tentacular Terminal| 2016
- 321
-
Study on the Possibility to Estimate the Vehicle Side Slip Using Two Independent GPS Receivers| 2016
- 331
-
Experimental Research on the Hybridization of a Road Vehicle| 2016
- 341
-
Study of Inductive Sensors for Automotive Applications| 2016
- 346
-
Considerations Regarding Validation through Simulation of Some Board System Information’s for Powertrain Performance Optimization| 2016
- 354
-
Implementing New IT Security Solutions in Automotive Immobilizer Systems| 2016
- 360
-
About Mechatronics in the Engineering Education at the Faculty of Mechanics Craiova| 2016
- 365
-
Aspects of Functional Optimization and Performance Evaluation Using an Experimental Programmable Engine Control Unit| 2016
- 375
-
A Comparison between a Composite Sandwich Bar with Polypropylene Honeycomb Core Reinforced with Steel Wire Mesh and Metallic Beams with Various Transversal Sections| 2016
- 381
-
Current State of Research on Bio-Source Composite| 2016
- 389
-
Establish Dependency Relations between Chemical Composition and Mechanical Properties of Aluminum Alloy 6082 AlSi1MgMn| 2016
- 397
-
Experimental Determination on Behavior of Composite Laminated Body Elements at Temperature Variations| 2016
- 403
-
New Concept Manufacturing Steering Column Console in Composite Materials| 2016
- 411
-
Prediction of Dissipative Properties of Flax Fibers Reinforced Laminates by Vibration Analysis| 2016
- 418
-
Research about the Quality of Bulk Titanium Materials Obtained by Powder Metallurgy Technology from Titanium Hydride Powder Used for Automotive Components| 2016
- 429
-
Study about Improving the Quality Process Performance for a Steel Structures Components Assembly Using FMEA Method| 2016
- 437
-
Thermal Source at Turning Allied Steel| 2016
- 443
-
Economical Model Based on Graph Theory for Optimization Execution Order of Automotive Products on the Manufacturing Lines Served by Robots| 2016
- 455
-
Adaptive Traffic Signal Control on a National Road Intersection| 2016
- 461
-
Determining the Projection Throw Distance of a Pedestrian upon the Collision with a Vehicle| 2016
- 472
-
Mathematical Model of a Dummy Cranio-Cervical Complex in Frontal Impact Testing Device| 2016
- 480
-
Optimal Analysis of a Route of the Public Transport System in Targu Jiu City| 2016
- 491
-
Studies Regarding Semaphoring Effectiveness in Oversaturated Intersections| 2016
- 497
-
Validation of Simulation and Optimization Reconstruction in PС Crash with Video Recorded Sample| 2016
- 503
-
Reconstruction of an Unusual Road Traffic Accident Using Two Different Versions of a Simulation Program| 2016
- 512
-
Studies Regarding Occupant Kinematics in the Vehicle at the Frontal and Rear Impact| 2016