Developing and Testing of Improved Control System of Electric Arc Furnace Electrical Regimes (Englisch)
Nationallizenz
- Neue Suche nach: Nikolaev, Alexander
- Neue Suche nach: Kornilov, Gennady
- Neue Suche nach: Povelitsa, Evgeniy
In:
Applied Mechanics and Materials
;
792
;
488-494
;
2015
- Aufsatz (Zeitschrift) / Elektronische Ressource
-
Titel:Developing and Testing of Improved Control System of Electric Arc Furnace Electrical Regimes
-
Beteiligte:
-
Erschienen in:Applied Mechanics and Materials ; 792 ; 488-494
-
Verlag:
- Neue Suche nach: Trans Tech Publications
-
Erscheinungsort:Stafa-Zurich, Switzerland
-
Erscheinungsdatum:07.09.2015
-
Format / Umfang:7 pages
-
ISSN:
-
DOI:
-
Medientyp:Aufsatz (Zeitschrift)
-
Format:Elektronische Ressource
-
Sprache:Englisch
-
Schlagwörter:
-
Datenquelle:
Inhaltsverzeichnis – Band 792
Zeige alle Jahrgänge und Ausgaben
Die Inhaltsverzeichnisse werden automatisch erzeugt und basieren auf den im Index des TIB-Portals verfügbaren Einzelnachweisen der enthaltenen Beiträge. Die Anzeige der Inhaltsverzeichnisse kann daher unvollständig oder lückenhaft sein.
- 3
-
Electromagnetic Induced Force Study in the Magnetoelectric Generator Winding| 2015
- -7
-
Preface, Committees and Organizers| 2015
- 8
-
Research of Non-Sinusoidal Voltage in Frequency Converter of Medium Power Operation| 2015
- 15
-
Concept of Designing Systems for Monitoring Technical State of Rolling Mill Electric Drives| 2015
- 21
-
Induction Traction Motor Mathematical Model to Control Thermal State| 2015
- 26
-
Hybrid Synchronous Motor Magnetic Field Analysis| 2015
- 33
-
The Comparison of Methods of Testing Enameled Wire to Mechanical Stress| 2015
- 38
-
Investigation of Non-Stationary Processes in a Nonlinear Inductor with the Massive Magnetic Core by Structured Modeling Methods| 2015
- 44
-
Building the Structure and the Neuroemulator Angular Velocity's Learning Algorithm Selection of the Electric Drive of TVR-IM Type| 2015
- 51
-
Turn-to-Turn Short Circuit Diagnostic Improvement Method Based on ANN for Synchronous Generator Excitation Winding| 2015
- 56
-
Mathematical Model of Synchronous Generator without Damper Windings which is Equipped with an Automatic Stabiliser| 2015
- 62
-
Increase Adjustment Capacity Generators for Power Supply Systems with Distributed Generation| 2015
- 67
-
Electromagnetic Motor with an Active Teeth-Slot Zone for Vibration Technologies| 2015
- 73
-
Investigation of Synchronization Properties of PM Machines with Fractional Slot Concentrated Windings| 2015
- 78
-
Additional Torque in Multipole Permanent Magnet Machines Caused by Eccentricity| 2015
- 83
-
A Sensorless Initial Rotor Position Estimation for Permanent Magnet Synchronous Machines| 2015
- 90
-
Developing a Highly Reliable Asynchronous Motor Development with an Asymmetric Magnetic Core for Special Operating Conditions| 2015
- 95
-
Simulation Modelling of a Pulse Frequency-Phase Discriminator| 2015
- 101
-
Induction Motor Traction Drive with Slipping Protection| 2015
- 107
-
An Analysis of the Main Factors on the Wear of Brushes for Brush-Type Motors and the Ways of Increasing their Lifetime| 2015
- 113
-
Respecting Life Cycle Management of Electrotechnical Equipment Based on Genetic Modeling Methods| 2015
- 122
-
Asynchronous Motor Operation Ability Investigation with Numerical Simulation| 2015
- 128
-
Improving Energy Efficiency of the Variable Frequency Drive of the Forced-Draught Fan with the Two-Speed Asynchronous Motor| 2015
- 134
-
Numerical Modeling of Dynamic Processes of the Reciprocating Reversible Electrical Machine| 2015
- 143
-
Research of Highly Effective Magnetoelectric Disc Type Synchronous Motor| 2015
- 147
-
Diagnosis of Inverter Drives Faults| 2015
- 155
-
Simulation of Voltage on Stator Winding Terminals of Induction Motor with Impaired Short-Circuit Winding of Rotor| 2015
- 160
-
Variable Frequency Control of Induction Motors for Emergency Demand Response| 2015
- 167
-
The Universal Mathematical Model of Excitation System of Synchronous Machines| 2015
- 174
-
Research Characteristics of Aluminum Alloy Obtained by the Method of Rapid Crystallization in Electromagnetic Field| 2015
- 183
-
Itinerant Phase Converter with Improved Energy Performance| 2015
- 189
-
Multilevel NPC Converters in Parallel Connection for Power Conditioning Systems| 2015
- 197
-
Stand-Alone Power Systems with IGBT Inverter| 2015
- 203
-
Francis Turbine Modeling for Hydrounit on the Bases of the Doubly Fed Induction Machine| 2015
- 209
-
Analysis of Power Operational Properties Transformers with a Core of Amorphous Materials| 2015
- 215
-
Subsynchronous Resonance in Independent Energo with Distributed Semiconductoring Load| 2015
- 220
-
Analysing the Impact of Electrical Displacement and Leakage Currents in Transformer Insulation on Voltage Measurement Accuracy| 2015
- 230
-
Population-Based Algorithms for Optimization of the Reactive Power Distribution and Selection of the Cable Cross-Section in the Power-Supply Systems| 2015
- 237
-
On Methods of Investigation of Power Generator Differential Protection Behavior in Automatic Mode| 2015
- 243
-
Equipment State Assessment System Based on Adaptive Neuro-Fuzzy Inference System (ANFIS)| 2015
- 248
-
The Impact of Distributed Generation on Power Quality of the Electric Network| 2015
- 255
-
Improving of Energy Measurements Reliability Using Weighted and Normalized Residual Analysis| 2015
- 261
-
Problem of Reliability, Verification of Electrical Power Systems Simulation and Ways of Solving it| 2015
- 267
-
Fixing Magnetically Operated Sealed Switches of Current Protections in Closed Electrical Pathways of Electrical Installations at 6-20 kV| 2015
- 272
-
Development of Calculation Methodology of Thermal Equivalent Circuit’s Parameters for Predicting Temperature of High Voltage Cable Lines 110 - 500 kV| 2015
- 280
-
Efficient Ways and Means of Reliability Increase of Distribution Networks| 2015
- 286
-
Phasor Measurements Application in Power Systems for Accelerated Power Flow Calculations in Emergency Control| 2015
- 293
-
Open Overhead Transmission Lines| 2015
- 300
-
Peculiarity of Determination of Economic Current Density Values for 6 – 35 kV Power Lines under Modern Conditions| 2015
- 305
-
Investigation of Defect Formation Process in Transmission and Distribution Equipment| 2015
- 312
-
Efficiency of Using Artificial Neural Network for Short-Term Load Forecasting| 2015
- 317
-
Decision Support System Based on the Concept of Hybrid Simulation for Dispatching Personnel of Electric Power Systems| 2015
- 324
-
Technical Diagnostics of Electric Equipment with the Use of Fuzzy Logic Models| 2015
- 330
-
Pre-Design Study for Construction of a Wind Power Station with the Capacity of 50 MW| 2015
- 339
-
Investigation of the Coal Char Conversion by Thermogravimetric Analysis| 2015
- 345
-
Long-Term Experience of Running Operation Boilers Equipped with Furnace Working upon High-Temperature Circulating Fluidized Bed| 2015
- 351
-
Combined Cycle Gas Turbine (CCGT) with Freon Steam Turbine| 2015
- 359
-
Method for Selecting Quantity and Power of Diesel Generators| 2015
- 364
-
High-Temperature Technologies of Electric Energy Production on Steam-Turbine Power Plants| 2015
- 370
-
Results of Mathematical Modeling to Study the Influence of Accounting the Process Moisture on Energy Indicators of Cogeneration Steam Turbines| 2015
- 375
-
Optimization of Pump-Throttling Substation of Heating Networks| 2015
- 379
-
Grid Wind Power Plant with Compensation of Active and Reactive Power| 2015
- 386
-
Power Plants Process Control Improvement in Emergency| 2015
- 393
-
The Analysis of an Air Condenser’s Performance in Russia's High Northern Climate| 2015
- 403
-
Assessment of the Impact of Sources of Funding on Project Successes Criteria of Energy Saving| 2015
- 410
-
Cross-Subsidization in Power Engineering| 2015
- 416
-
Mechanisms of Destruction by Alternate Current| 2015
- 422
-
Energy Efficiency of Investment Projects Public and Private Partnerships| 2015
- 428
-
Energy Service Contracts: Russian Practices| 2015
- 433
-
Impact Analysis of Excessive Fuel Consumption on Technical and Economic Performance of Coal-Fired Co-Generation Units| 2015
- 439
-
Assessment of Administrative Labor Organization in Electrical Engineering| 2015
- 446
-
Optimal Control Mode of the Vakhsh Hydropower Reservoirs to Reduce Electricity Shortages in Tajikistan| 2015
- 453
-
Electrical Parameters of Induction System for Internal Cylindrical Surfaces being Heating| 2015
- 457
-
Studies of Electromagnetic Stirrer Modes| 2015
- 462
-
Optimization of Induction Heating Regarding Typical Quality Criteria: Problem Solution Based on 2D FEM Analysis| 2015
- 468
-
Analytical Analysis of Electromagnetic Processes in System "MHD Stirrer - Bath with Melt"| 2015
- 476
-
Permanent Magnet Heater for Special Applications| 2015
- 482
-
The Study of the Thermal Processes in an Electrode Influenced by an Electric Arc| 2015
- 488
-
Developing and Testing of Improved Control System of Electric Arc Furnace Electrical Regimes| 2015
- 495
-
Investigation of Electrical Parameters of Interleaved Conductors' Packages in High Power Electrotechnological Installations| 2015
- 499
-
Mathematical Simulation of Acoustic Characteristics of Super-Power Arc Discharges in Electric Steel Furnaces| 2015
- 505
-
Design Optimization of Induction Heater in Planetary Reactors for Semiconductor Industry| 2015
- 511
-
Calculation of the Melt Surface Shape in Different Induction Crucible Furnaces| 2015
- 519
-
Eddy Current Impact Estimation in Designing Vibroisolator with 3D Electromagnetic Stiffness Compensator| 2015
- 524
-
Characteristics Description of Electromagnetic Stiffness Compensator| 2015
- 529
-
Switching Converters Development Systems for Electrostart Diesel Engine Start| 2015
- 536
-
Application of Energy Storage Devices at the Road City Transit Rolling Stock| 2015
- 542
-
Ways of Decreasing Fuel Consumption in Vehicles| 2015
- 546
-
Mechanical Oscillations Simulation of an Adaptive Flexible Mirror| 2015
- 553
-
Improved Cleaning of the Engine Cylinder from the Exhaust Gas Using the Active Ejection in the Exhaust Tract| 2015
- 559
-
Energy-Saving Potential from Use of Heat-Reflective Screens with Solar Battery in Windows for Power Supply Systems of Buildings in Different Regions of Russia and France| 2015
- 568
-
Experimental Study on Electroplastic Effect in AISI 316L Austenitic Stainless Steel| 2015
- 572
-
Enhancing Resistance of Cables to Hydrocarbons| 2015
- 578
-
Improvement of Electrical Insulating and Anti-Wear Properties of Composites Used in Telemetry Systems| 2015
- 582
-
Iterative Approach in Design and Development of Vertical Axis Wind Turbines| 2015
- 590
-
Hardening of Aluminum Alloys with Nano-Dispersed Inclusions during the Implementation of Energy-Saving Process of Self-Propagating High-Temperature Synthesis in Aluminum Melt| 2015
- 596
-
Synthesis of MAX-Phase of Titanium Silicon Carbide (Ti3SiC2) as a Promising Electric Contact Material by SHS Pressing Method| 2015
- 602
-
Optical Recording of Bubble Dissolution of Diagnostic Gases in Electrical Insulating Liquids| 2015
- 606
-
Transport System of Viaduct Type| 2015
- 610
-
Probability of the Spectrums Overlap in Case of Carrier Frequency Random Shift in Asynchronous Radio System without Feedback| 2015
- 617
-
Improving the Operating Efficiency of Wells with Electrical Submersible Centrifugal Pump in the Fields with Hard to Recover Reserves| 2015
- 623
-
In Situ Studies of Molecular Self-Assembling during the Formation of Ion-Conducting Membranes for Fuel Cells| 2015
- 629
-
Influence of the Vehicles’ Shape and Length on its Pressure Drag Value Investigation| 2015
- 635
-
Determination of Internal Heat Power during the Induction Heating Based on Solution of Linear Inverse Heat Conduction Problem| 2015
- 640
-
Thermal Annealing Effect on Active Layer Structure in All-Polymer Organic Solar Cells| 2015
- 645
-
Metallurgy and Ancient Coins: A Multidisciplinary Research| 2015